![]() The other task is to ping vlan10 interface of Titanium1. Router 3725 Vlan1 interface seems to be up and reachable. Picture 13 Pinging local interface vlan10 on router 3725 Test if we can ping vlan10 IP address 192.168.3.3 locally from CLI of router 3725. ![]() We have finished Titanium1 configuration. Picture 11 Pinging vlan1 interface IP address ![]() However we can still ping vlan1 inetrface IP address 192.168.3.1 as it is shown at the picture. Once vlan1 interface has been brought up a warning message "crashed service netstack" has appeared as it is captured at the picture. Picture 10 Titanium1 Vlan, trunk a vlan interface configuration In order to create layer3 vlan interface, following command has to be issued. Picture 9 元 connection is working on routed ports of TitaniumĬreate VLAN 10 and configure ethernet 2/2 as a L2 trunk port. Once IP addresses are assigned to the interfaces we should ping instances each other. ![]() Now configure particular IP addresses for eth2/1 interfaces on both Titanium instances. Picture 8 L2 connection is working on routed eth2/1 ports of Titanium To ping IP address of management interface just issue command:Īs interface mgmt0 is up on both Titanium instances by default instances should see each other using CDP protocol. Username/password for Titanium is admin/cisco.įrom what we see, one management port mgmt0 and one Ethernet module with 9 interfaces are presented in Titanium1. Use console (Right click on device) to connect to device serial port. For 元 connectivity interface vlan 1 is created on the router. Both ports are L2 trunk ports connected to Titanium instances. Ports f1/0 and f1/1 are interfaces located on NM-16SW module that is inserted in the router 3725. For layer3 connectivity interfaces vlan1 are created on both instances. There are also switched trunk ports eth2/2 on both Titanium instances connecting instances to the router 3725. Titanium ports eth2/1 and mgmt0 are routed 元 ports connecting instances each other. Two Titanium instances are connected to 3725 router occupied with NM-16SW module. NxOS Emulator Titanium 5.1(2) VMware imageĪssuming that you have Qemu emulator installed and working set Qemu Guest settings as following. GNS3 0.8.3.1 installed on Fedora 17 Linux As GNS3 has built-in support for Qemu and Qemu can work with VMware vmdk images no cloud connection is needed for connection to external devices. ![]() The tutorial shows how to do connect Titanium VMware image to GNS3 using Qemu emulator. A copy of Titanium 5.1.(2) installed on VMware image has recently leaked to the Internet and now we can use it for our studies. Titanium is Cisco Nexus Operating System NX-OS emulator made by Cisco. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |